562-608-8777
info@tss-sales.com
SuisseNano - Grizzly® Coating
Grizzly® Coating Spay-Bottle Deposition Instructions:
Step-1
- Clean and dry the glass surface prior to coating deposition.
- Water and ethanol-based glass cleaners are most efficient.
- Paper towels best used for cleaning and drying of the glass.
- Visually inspect the glass surface and make sure it’s completely clean and dry.
Step-2
- Spray GRIZZLY® coating solution by pumping 6-7ml per 1m2 of glass surface.
- Use paper towels or similar products to evenly spread the liquid around the entire surface.
Additional Important Notes
The glass surface should not be cold, 68°F and above is the optimal deposition temperature.
The glass can be immediately moved down the production chain after step 2 and no interruption of production process is needed. The coating dries and reacts with the glass immediately, fully cures within hours.
Leaving portions of the glass surface area non-wetted by GRIZZLY® will not coat/functionalize these areas.
Deposition process efficiency: 2m2 in 3’ per one deposition station with one worker.
Industrial Deposition Options:
On Average, 3 shifts: 20M ft2 coated per annum Vertical Washing + Coating Line
Line dimensions:
Line length:13.2m (44ft)
Line height:3.5m (11.5ft)
Line width:2.2m (7.3ft)
Line speed:
7m/min (23ft/min)
Typical glass dimension:
Glass height: 0.5 - 3m (1.64ft - 9.8ft)
Glass width:0.1-2.2m (0.33ft - 7.2ft)
Glass thickness:3-19mm (0.11”-0.75”)
Line throughput at 2/3 load factor, 1 shift (8hrs):
2m (6.6ft) x 1m (3.28ft) x 8mm (0.31”)
Glassglass: 570,000 m2 / year OR 6.1M ft2 / year
2m (6.6ft) x 1.5m (4.9ft) x 8mm (0.31”)
Glass857,000 m2 / year OR 9.2M ft2 / year
Warranty
SUISSENANO SA
warrants that its industrially applied GRIZZLY® coating if properly applied and maintained protects a glass surface against glass corrosion and remains water repellent (water contact angle above 70 degrees) for a lifetime of the glass surface.
Proper industrial application encompasses uniform deposition atop of a clean glass surface in the amount specified by the coating supplier.
Proper maintenance encompasses avoiding harsh chemicals or abrasives for coated surface maintenance
SUISSENANO SA
shall be the sole judge as to whether the proper application practice and maintenance recommendations have been followed. If following a technical investigation, it is found that the coating failure has originated from the improper industrial application or maintenance practices, then SUISSENANO SA shall be released from its obligation or liability under this warranty.
SUISSENANO SA
liability is limited to the cost of replacing chemicals for reapplication and will in no way extend to indirect, incidental, or consequential damages incurred in relationship to this product.
